Small-scale recycling of waste tires to oil pyrolysis plant

waste tires to oil pyrolysis p|tire pyrolysis plant||
Contact suppliers

Scrap tires are a common waste product in many car repair shops. How do you solve these wastes? DOING splits the waste tires into fuel, carbon black, steel wire and combustible gas according to the principle of waste tire pyrolysis plant.

The main workflow of DOING's waste tire pyrolysis plant is:

1. The waste tires are fed into the reactor via an automatic pusher.

2. The reactor is heated. When the temperature reaches a certain level, the waste tire will be cracked into oil and gas. Some of these oils and gas will be liquefied through the condensing system and flow into the tank; the other part of the uncondensed gas will be condensed and liquefied again into heavy oil to flow into the tank or used as a fuel heating reactor.

3. Dust removal and deodorization of the heavy oil collected in the tank. Remove fumes or odors from the combustion process.

4. When the reactor is cooled to below 40 degrees, remove the carbon black from the reactor.

What are the benefits of running our equipment? After being accurately measured by engineers, the operation of our equipment can earn nearly 2,000 US dollars a day. These gains are mainly due to fuel, carbon black, and steel wires that are cracked out of equipment. The specific uses of these materials are as follows:

1. Fuel oil: Mainly used in iron and steel plants, boiler heating, heavy oil generators, and cement plants.

2. Carbon black: It is mainly used for pressure ball combustion and refined milling. Refined flour can be used for new tires, rubber soles, and pigments.

3. Steel wire: mainly used for waste recycling and recasting.

Of course, this kind of profit can be attributed to the high oil output rate of DOING waste tire pyrolysis plant, and the high oil output rate is closely related to the following advantages of the waste tire cracking equipment. The specific advantages are as follows:

1. Adopt Q245R standard boiler plate, plate thickness is 16mm, can withstand high temperature and high pressure.

2. Using a unique 3-step welding process, it is not easy to crack and has a long service life.

3. External insulation system is installed outside the reactor to avoid heat loss and save energy.

4. The pinion rotating device has a low power and does not directly contact the reaction vessel. It has less heat transfer and is not easily deformed.

5. With safety devices, oil-water separators, water seals, vacuum devices. Can purify oil and gas, tail gas, prevent oil and gas, tail gas backflow. And can provide negative pressure device to drain oil and gas.

Contact: Ms Bonnie
Phone: +86-371-5677 1821
Skype: bonniezhao2